One of the most common repairs in the home is repairing a leaky faucet. They are common in older homes since compression faucets have been around the longest. However, many homeowners don’t know what type of faucet they have in their home due to a variety of faucets available. You must ensure that you have a compression faucet before reading the rest of this article.

Compression faucets shut off the flow of water with the use of a washer which tightens when compressed. They will eventually wear out frequently since these washers. They are considered as an old school because they tend to have few parts you have to disassemble if you want to replace the washer though it is really not that hard.

Turn Off the Water Supply at the Sink

Locating the water shutoff to your faucet and turning it off is the first step in the fixing a broken compression faucet. It consists of a small handle and valve that is usually found directly under the sink. Turn the handle clockwise to tighten and shut it off if the valve is similar to the old school style.

You may need to go to the water main and shut off the water supply from there if your home does not have shut off valves. Open the faucet fully to release any pressure and letting the water drain out once the water is shut off.

Remove the Faucet Handle

By a screw concealed under a cover cap, the handle body will be attached to the faucet valve stem. It screws into the handle and the older faucet is often metal. You must get a pair of pliers and grip the cap to unscrew it to gain access to the screw holding the handle.

It will reveal a screw that holds the handle onto the valve stem once the cap is removed. You can then remove the screw and slowly pull off the handle.

Remove the Valve Stem Assembly Cover

You will typically find a cover over the valve stem assembly once the handle is removed. Unscrew the knurled knob that joins it together and then removes the cover if you want to remove the valve stem assembly cover.

Remove the Valve Stem and Assembly

You will see at the top of the valve stem assembly has a hex shape nut at the base of the exposed system. You must unscrew the valve stem assembly from the housing. You can also use channel-lock pliers or pipe wrench.

Remove Old Washer and Replace with a New Washer

You will find the old washer on the end sticking in a valve seat once the valve stem assembly is removed. It will look pretty well beaten and crushed; it will be held in place with a screw. By removing the brass screw, you can get the old washer. The next thing to do is reassemble the faucet and restore the supply of water.

If you are planning to hire professional plumbers, then there are many companies that will provide you with professional services such as plumber near me that offers high-quality work and makes sure that their clients are satisfied.